Table of Contents
Advertisement
24/52
Transport and storage
After removal
Bosch Rexroth AG, A2FM/A2FE Series 70, RE 91071-01-B/03.2015
A dismounted axial piston unit must be stored with corrosion protection for the
duration of storage.
The following instructions only refer to axial piston units which are operated
with a mineral oil-based hydraulic fluid. Other hydraulic fluids require
preservation methods that are specifically designed for them. In such cases,
consult Bosch Rexroth Service, see Chapter 10.5 "Spare parts" on page 43.
Bosch Rexroth recommends the following procedure:
1.
Clean the axial piston unit, see Chapter 10.1 "Cleaning and care" on page 41.
2.
Empty the axial piston unit.
3.
For storage periods up to 12 months: Coat the inside of the axial piston unit with
mineral oil and fill with approx. 100 ml mineral oil.
For storage periods up to 24 months: Fill the axial piston unit with corrosion
protection VCI 329 (20 ml).
Fill through the drain port T
Fig. 10 to Fig. 11 on page 33.
4.
Seal all ports so they are airproof.
5.
Moisten the unpainted areas of the axial piston unit with mineral oil or suitable,
easily removable corrosion protection, e.g., acid-free grease.
6.
Package the axial piston unit with desiccant in corrosion protection film so it is
airproof.
7.
Store the axial piston unit in a non-explosive area in a manner that is shock-proof,
see "Requirements" on page 23 in this chapter.
or T
, see Chapter 7.4 "Installing the axial piston unit",
1
2
Advertisement
Table of Contents
