Introduction; Before You Start; Package Contents - Motorola Avigilon ACC VMA-ENVR1-8P4 User Manual

Introduction

The Avigilon ACC ES 8 Port Appliance is the all-in-one solution for network video recording. The recorder
features:
A network switch to connect and power IP cameras.
l
Built-in server to run the Avigilon Control Center Server Software.
l
Local video content storage that can be accessed remotely.
l
The ACC ES 8 Port Appliance factory default settings allow you to use the recorder immediately after
installation, but if you have special requirements, you can use the Avigilon Control Center software or the
web interface to customize your settings.
Before You Start
Avigilon recommends the use of an uninterruptible power supply (UPS) system to protect your video
surveillance system hardware. A UPS system is used to protect critical equipment from mains supply
problems, including spikes, voltage dips, fluctuations and complete power failures using a dedicated
battery. It can also be used to power equipment during the time it takes for a standby generator to be
started and synchronized.
Any UPS connection must include configuration to shut down the operating system on the appliance when
battery power is low or there is 15 minutes of power remaining.
It is recommended that cameras not be connected to the appliance until after the appropriate network
configuration has been set up.

Package Contents

Ensure the package contains the following:
Avigilon Video Appliance
l
Power cord
l
Power supply and screwdriver to secure it
l
Wall installation hardware
l
Digital input/output terminal block connector
l
Introduction 1