Managing Acc Services And Storage - Motorola Avigilon ACC VMA-ENVR1-8P4 User Manual

powered
Gray Disconnected There is no device connected to the port.
Unpowered
Yellow Overloaded
Low current
Red Error
Tip: If a camera is disconnected then reconnected to the device, you may need to refresh this page
to view the latest status and budget values.

Managing ACC Services and Storage

On the Server panel use the:
General pane:
l
To...
Shut down all the services before you shut
down the device.
Start up all the services after they have been
shut down.
Format the storage drive.
Network Storage Management pane:
l
To allow users to archive video from this device using the ACC Client software:
1. Click Enabled.
2. From the Protocol drop down list, select one of the following:
CIFS — Common Internet file system. The network path is typically in this format:
l
//<hostname or IP> / <path>
NFS — Network file system. The network path is typically in this format: <hostname or
l
IP> : <path>
3. In the Network Path field, enter the path to the preferred video archiving location.
Managing ACC Services and Storage
The PoE port power is switched off from the PoE page in the ACC ES Admin
Web UI
A PoE device is connected to the port but is not receiving power. This status
typically occurs when one port is overcurrent, or the device is requesting more
power than budgeted, etc.
The device is getting low current from the port.
The device is in an error state.
Do this...
Click Stop.
Click Start.
Click Reinitialize to delete all configuration and
recorded video data.
11