Isolates - Haier Ampac ZoneSense PLUS Operation Instructions Manual

5.2 Isolates

To display the number of Isolates press Enter to access the menus then Move Left or Move Right to
select the required menu. The number of isolates will be displayed for each step.
Zone [ Main Brd ]
Zones 1 to 8 are
Active or Isolated

Note: The Relay and Sounder Isolate Menus are only displayed if the boards are installed in the
FACP and set to active in the System Menu.
Main Control Board Zone, Relay Board or Sounder Board Isolates
Press Enter and use the Move Left or Move Right keys to select the Zone, Relay or Sounder number
then the Move up to key isolate or Move Down key to make active (set) the required Zone, Relay or
Sounder.
ZONES
X ISOL'D
Press Enter

Note: X denotes the Zone number, substitute Relay or Sounder for those menus.
If a Zone or Zones are Isolated the Isolate LED for that Zone and the common Isolated LED will be
illuminated. If a Relay or Relays, Sounder or Sounders are isolated only the common Isolate LED will be
illuminated. The Isolate can be deactivated by pressing ISOLATE / DE-ISOLATE while in the Output menu
or repeating the steps above to de-isolate (make Active) individual Zones.
Main Control Board Outputs Isolates
Press Enter to access the Isolate – Main Control Board Monitored Outputs sub-menus as seen below
Bell Warn Sys
Use the Move Right or Move Left keys to select the required menu and the Move Up key to
Isolate or  the Move Down key to active.
Monitored Outputs
[ Main Brd ]
Bell
ZONE 1
Active
 Select Zone Number
ACF
Relay [ Relay Brd ]
Relays 1 to 8 are
Active or Isolated
Only available if relays and or sounders are installed
Warn Sys ACF
set, Active or Isolated
ASE Alarm
MAN1564-3
Sounder [ Sndr Brd ]
Sounders 1 to 8 are
Active or Isolated
ASE Alarm Fault
ZONE 1
Isolated
Fault
18