Installing The Cable Tray; Parts List; Procedure - HP E840 A Series User And Service Manual

WARNING

Installing the Cable Tray

Parts List

Procedure

34 Rack Mounting and Option Installation
10.Slide the rack slide intermediate sections out from the rack slide
stationary sections until they lock into place. With one person on each
side, lift the mainframe and slide the chassis sections into the
intermediate sections until the chassis sections lock into place. Slide
the mainframe into the rack until the rack mount adapter flanges are
against the rack's vertical rails. Secure the mainframe to the rack
using the adapter dress screws.
To prevent injury during rack mounting, the mainframe should
be empty and two people should lift the mainframe into the
rack.
The HP E840xA Cable Tray (Option 914) allows you to route VXI
instrument cables and wires under the mainframe. The cable tray can be used
when the mainframe is on a bench top or when mounted in a standard EIA
cabinet. The tray is compatible with the support rail (HP E3664A) and rack
slide (HP p/n 1494-0411) kits.
Note
If you ordered the support rail (HP E3664A) or rack slide (p/n 1494-0411)
kit, install the cable tray before rack mounting the mainframe.
The parts included in Option 914 are shown in Table 2-3.
Table 2-3. HP E840xA Cable Tray Option 914 Parts List.
Quantity
1
4
1. Remove the four mainframe feet by lifting the tabs and moving each
foot towards the center of the mainframe.
2. Attach the cable tray to the mainframe as shown in Figure 2-11 using
four m5x8 pan head screws. Select the tray holes based on the amount
of cable clearance required.
The bottom mounting holes position the tray over one additional EIA
rack unit (44.5 mm), the top holes position the tray over two EIA rack
units, and the center holes position the tray between one and two EIA
rack units.
Description
Cable Tray
Cable Tray-to-Mainframe Screws -
m5x8 pan head
Part Number
E8400-04102
0515-0979
Chapter 2