Canon DP-V2730 Operation Manual page 37

Sub Menu
Image Division
Screen A ~ D
Link Order
When [Input Configuration] [12-3G/HD-SDI]
Sets the display method when using either [Quad Input] or [Dual Input]. Two division methods
"Square Division" and "2 Sample Interleave" are supported for 4K video signals.
When [Input Configuration] [Multi View]
The multi-screen display method can be selected from [Multi View (Quad)] or [Multi View (Dual)].
Automatic [Automatic]: Automatically determined based on payload and displayed.
[Square Division]: Displays a signal transmitted over four inputs as a single
[Select Input Signal]
When [Quad Input] [2 Sample Interleave]: Displays a signal transmitted divided into a 2K/HD
Square Division
2 Sample Interleave [Multi View (Quad)]: Each of the images from the four inputs are shown in
Multi View (Quad)
[Multi View (Dual)]: Each of the images (Inputs A/B or Inputs C/D) from the
[Select Input Signal]
When [Dual Input]
2 Sample Interleave
Multi View (Dual)
Select Input Signal: Q uad Input, Image Division: Square Division
• The combinations of video signal formats that can be displayed when using two
screens or four screens in [Multi View (Quad)] or [Multi View (Dual)] are as follows:
- Resolution combinations: Same, or "4096x2160, 2048x1080", "3840x2160,
- When using a frame rate and I/P/PsF combination that is one of
- (Quad screen display only) For both left and right, when the top and bottom
There may be periodical deterioration in the image when inputting signals with
differing frame rates or I/P/PsF.
• For 2048x1080 images when using [Multi View (Quad)] or [Multi View (Dual)], the
images are displayed in reduced size when [Screen Scaling] is set to [Automatic].
The left and right parts of images will be trimmed for display when anything other
than [Automatic] is selected.
SDI Input A When [Input Configuration] [Multi View] is selected, sets which
SDI Input B terminal's signal is to be displayed on the selected screen.
SDI Input C
SDI Input D
HDMI
Automatic Automatically detects and displays correct terminal order based on
Off payload when using [2 Sample Interleave].
Setting Options
image.
signal as a single image.
four screens.
two inputs are shown in two screens.
1920x1080"
"23.98P / 24P / 25P / 29.97P / 30P"
"I (All) / PsF (All) / 47.95P / 48P / 50P / 59.94P / 60P"
screen video signal frame rates and I/P/PsF are the same
OSD Menu
37