Table of Contents
Advertisement
Replacing projector mount bracket (ET-PKC300B) (continued)
Installing the connecting plate
Align the ends of the four long holes on the connecting plate to the four screw holes on the projector
1)
mount bracket.
z Make sure the arrow marks on the connecting plate point to the left and the "CENTER" mark on the
projector mount bracket is in the front side. (Fig.1)
Secure the connecting plate to the new projector mount bracket using the supplied four captive
2)
washer screws (M4 × 14). (Fig.2)
Install the supplied drop-prevention wire rope and the new projector mount bracket to the projector.
3)
z For details, refer to "Attaching the projector drop-prevention kit" ( x page 11) and "Installing the projector
mount bracket kit to the projector" ( x page 11).
Screws
Fig.1
Ends of long holes
Arrow mark
Fig.2
ENGLISH - 21
Advertisement
Table of Contents
