Table of Contents
Advertisement
Installation (ET-WBC100) (continued)
Secure the projector mount bracket to the wall mount bracket using the four supplied flanged screws
4)
(M4 × 10). (Fig.4)
z Tightening torque of flanged screws: 0.8 ± 0.2 N·m
z If the brackets interfere with the Phillips screwdriver, making it impossible to tighten the flanged screws on
the wall side, pull out the arm and tighten the screws. For details on how to pull out the arm, refer to "When
adjusting the projected image size (forward/backward slide)" ( x page 16).
Route the wire rope through the arm and pull it out to the top of the wall mount bracket. (Fig.5)
5)
Flanged screws
Attaching the wire rope to the wall
Secure the other end of the wire rope attached to the projector to the wall.
* These instructions assume installation in a concrete wall and use of commercially available M10 suspending
bolts, anchor nuts or curled plugs. You will also need one commercially available flat washer with an outer
diameter of at least 30 mm.
Mount the anchor nut or curled plug (M10) firmly in the concrete wall. (Fig.1)
1)
z When installing to a wooden structure, drill a hole in the wall and install the commercially available
suspending bolt (M10) with a commercially available flat washer (M10) and hex nut (M10). (Fig.2)
14 - ENGLISH
Arm
Fig.4
Anchor nut or curled plug
Fig.1
Flanged screws
z When installing to a wooden structure
Flat washer
Hex nut
Suspending bolt
Wire rope
Fig.5
Wall
Fig.2
Advertisement
Table of Contents
