Network Status; Top Page - Epson TM-P20II Reference Manual

10.1.2 Network Status

In the Confirm Network Settings, you can confirm the product's network settings.

10.1.2.1 Top Page

10.1.2.1.1 Image
10.1.2.1.2 Tab
"Network" and "Wi-Fi Direct" tabs are displayed on model that support wireless functions. You can switch between both sets of
displayed information.
10.1.2.1.3 Display items
The following table shows the display items for both model that support wireless functions and model that do not support wireless
functions.
Items
"Device Name"
"Connection Status"
"Signal Strength"
"Obtain IP Address"
"Set using BOOTP"
Figure 10-2 Network Status
Table 10-9 Displaying items (Network)
Description
Shows the name of the printer.
"Disconnect" / "10BASE-T Half Duplex" / "10BASE-T Full
Duplex" / "100BASE-TX Half Duplex" / "100BASE-TX Full
Duplex" / "1000BASE-T Full Duplex"/ "Unknown"
"Wi-Fi Disconnected" / "Searching for Wi-Fi" /
"W-Fi-xxxMbps" ("xx": "00" - "495") / "Unknown"
"Disable"
"Excellent" / "Good" / "Fair" / "No Good" / "Unknown"
"Auto" / "Manual"
"Enable" / "Disable"
Display Items
Button
Condition
-
Shown when the wired LAN is used.
Shown when the Wi-Fi is used.
Shown when both the wired LAN and
the wireless LAN are disabled (only
Wi-Fi Direct Mode is used).
Only shown when wireless LAN is
used. Not shown while Wi-Fi Direct is
used.
Not shown when Connection Status
is disabled.
If "Obtain IP Address" is "Manual", this
item is not shown.
41