Bosch B426 Installation And Operation Manual page 15

Conettix Ethernet Communication
Module
Notice!
Before trying the AutoIP option, ensure that the web browser is not configured to use a proxy
server. Refer to the browser's online help for instructions on disabling proxy service.
If the module's IP address is not recorded in the host computer's ARP table and you do not
know the address, set the rotary switch to the 0 position, cycle the power to the module, and
then follow the steps below.
Using the AutoIP:
1.
2.
3.
If AutoIP does not work on the host computer, a new registry key might be required to enable
AutoIP. Be sure to obtain permission from your company IT department before changing the
registry.
To enable AutoIP on the host computer with a new registry key:
1.
2.
3.
4.
5.
Figure 5.1: B426 Login page
Bosch Security Systems, Inc.
Direct connect the B426 to the Ethernet port on a computer and wait 60 sec. If AutoIP
service is enabled on your PC, a 169.254.XXX.XXX address should now be assigned to
your PC.
Open an internet browser (Microsoft Internet Explorer 6 or higher, or Mozilla Firefox 3 or
higher) and type in the default AutoIP address for the B426: 169.254.1.1, and press
[Enter].
Enter the default password: "B42V2" and click Login. The Device Information page
opens.
Open Notepad and create a new file called AutoIP.reg.
In Notepad, include the following text:
Windows Registry Editor Version 5.00
[HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Tcpip\Parameters]
"IPAutoconfigurationEnabled"=dword:00000001
Save the file to a location on the host computer that you can easily find.
Navigate to the saved file and double-click on it to add it to the host computer's registry.
Restart the host computer.
Installation and Operation Guide (UL)
Configuration | en 15
2013.08 | 02 | F.01U.281.208