ABB i-bus KNX Product Manual page 148

ABB i-bus® KNX PARAMETERS
—
7.9.4.1.3
DEPENDENT PARAMETER
Determine slat adjustment time
This parameter can be used to define how the slat adjustment time is determined.
The slat adjustment time is the time required to open or close the slats completely.
This parameter is available only in Operating mode Blind/shutter control with slat adjustment .
Options
Via duration of slat adjustment
(step)
Via total duration for slat
turning
Options
Via duration of slat adjustment
(step)
Via total duration for slat
turning
Condition for visibility:
Parameter window Blind/Shutter \ Parameter Parameter setting \ Option Individual
—
7.9.4.1.3.1
DEPENDENT PARAMETER
Duration of slat adjustment (step)
This parameter can be used to define the duration of a single slat adjustment (Step).
Options
50 ... 200 ... 1,000 ms
Condition for visibility:
Parameter window Blind/Shutter \ Parameter Parameter setting \ Option Individual \ Parameter Deter-
mine slat adjustment time \ Option Via duration of slat adjustment (step)
Note
The slat adjustment time is calculated using the duration of a single slat adjustment (step) and the
number of slat adjustments.
Refer to the motor's data sheet for the duration of a single slat adjustment.
The duration of a single slat adjustment multiplied by the number of slat adjustments results in the
slat adjustment time.
•
The slat adjustment time is determined via the total duration for slat turning and the number of slat
adjustments.
The total duration for slat turning must be determined manually.
•
•
The device cannot process times shorter than 50 ms. The calculated time (quotient of total duration
for slat turning and the number of slat adjustments) must therefore always be longer than 50 ms.
•
Duration of slat adjustment (step)
Total duration for slat turning from 0 % - 100 %
Duration of slat adjustment (step)
Total duration for slat turning from 0 % - 100 %
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 148