Table of Contents
Advertisement
Publication no. 201101
3.7 Remote control
Selecting this item will present a window where the up- and download of a set-up is per-
formed.
Remote control
Connect
Use the up and down arrows to move the cursor between the settings, and use Previous and
Next soft-keys to select option.
Connect to Selects which communication port to use, HOST or AUX1. Default is AUX1.
Selects the baudrate for the data transmission, 300, 600, 1200, 2400,
Speed
4800,9600,19200, 38400 or 57600. Default is 38400.
For up- and download setup's the following equipment are required.
• A PC compatible computer with a standard RS232 serial interface.
• A pin-to-pin cable with a female 9-pin DSUB on one end and a male 9-pin DSUB on the
other end.
• The software, NICManager, runs under WINDOWS 98/ME and WINDOWS 2000/XP.
The NICManager is a freeware program and can be downloaded from Triacon's home-
page.
3.7.1
Save and Load a Set-up
To save or load a set-up the following must be performed:
• Connect a PC to the Network ID Camera's AUX1 or HOST connector.
• Start up the 'NICManager' program and make sure that all settings are correct, please
refer to the program help file.
• Enter "Remote control" on the Network ID Camera and select communication port and
speed.
• Press F1 "Connect", a text "Waiting" appear on the display. The camera is now ready for
a transmission session.
Start the transmission from the PC.
• When done, press F4 on the Network ID Camera to exit remote mode.
NOTE
Before a setup is loaded to the Network ID Camera the current setup will be erased. If
download is interrupted for some reason a new download must be performed. If there is
problems to download a set-up, even at lower speed, the setup should manually be
erased. This since the partially loaded setup may be inconsistent causing the camera to
behave incorrectly. To manually erase a setup (i.e. resetting to customer default), please
refer to "3.1.1 Resetting to customer default" on page 3.
October 2005
NICLan not connected
Connect to: AUX1
Speed: 38400
Previous
Next
30
NIC2-2 · Installation and Set-up Manual
Exit
Triacon AB Sweden
Advertisement
Table of Contents
