Table of Contents
Advertisement
NIC2-2 · Installation and Set-up Manual
1. General
This manual describes how to install and setup the Network ID Camera herein
called NIC. This includes anything from installation to setting-up what the pic-
ture printed on the film should look like, which language for the display, to how
it should communicate with a booking system.
This manual is written for software version 3.32 and it is assumed that lan-
guage is set to English. Note that you may select language to English which
causes all texts to be displayed in English, but still select country to the country
you are in to get country-dependent information, like date format and PID num-
ber, correct.
2. Installation
2.1 Unpacking
Check that the cardboard box is undamaged and has no holes or deep scratch-
es. Any damage must be reported to the transport company or the supplier
whenever it can be suspected that the camera has been damaged during
transport.
The box contains the camera, an operator's manual in local language and the
power cord. The keyboard should be equipped with the country dependent
keycaps.
2.2 Installation Details
After unpacking the camera it should be placed on a steady table or shelf. If the
camera is operated in mobile units like mammography screening buses, or
where there is a risk of the camera falling down, it should be fastened to the
surface with two screws mounted from the inside of the camera through two
holes in the bottom plate with suitable screws.
The power cord should be connected to the power receptacle on the backside
of the camera and to wall outlet.
No voltage selection is necessary, the camera can be operated at any
voltage from 100 to 250 VAC 50/60Hz.
Triacon AB Sweden
Power receptacle
1
Publication no. 201101
October 2005
Advertisement
Table of Contents
