Mounting The Gp/Ht/Pro Radio On The Wall/Din Rail; Wire Connections - Motorola IRRInet-M DC Owner's Manual

Mounting the GP/HT/PRO Radio on the Wall/DIN Rail

1. Connect the Audio Accessory Adapter
(Item 1) to the radio.
2. Insert the audio communication cable
(FKN8431A) (Item 2) into the Audio
Accessory Adapter.
3. Insert the BNC Antenna Adapter into the
radio (Item 3).
4. Snap the radio into the DC Adapter
(FCN5516B) (Item 4).
5. Insert the DC cable (FKN8542A) into the
DC Connector of the DC Adapter (Item
4).
6. Wall mount: Using the holes on the Mounting Bracket (Kit FCN5516B) and two screws
(not provided), mount the radio near the installed IRRInet M.
7. DIN Rail mount: Using the two screws, connect the two DIN rail radio connectors (#
0786144U08) to the Mounting Bracket (Kit FCN5516B). Then use these connectors to
attach the radio to the DIN rail near the installed IRRInet-M.

Wire Connections

Perform wire connections as shown in Figure 25.
1. Connect the audio communication cable (FKN8431A) from the Audio Adapter (attached to the
radio) to the Port 3 communication connector of the IRRInet-M.
2. Connect the DC power cable (FKN8542A) from the DC Adapter (attached to the radio) to the
AUX power connector of IRRInet-M. Make sure the AUX power is set to 7.5V DC. Set the
middle knob (channel select knob) to Channel 1.
3. Connect an antenna cable (FKN8434A or equivalent, not provided) to the BNC Adapter on the
radio.
4. Use the clamps provided in the kit to route and secure the audio communication and DC power
cables.
Appendix B: Models, Options and Accessories
3
2
1
39
Fit radio to
chassis
base and
press radio
to chassis
4