Network Settings; Overview; Preparation; Setup Method - Canon CXDI-40G COMPACT Service Manual

9. Network Settings

9.1 Overview

CXDI-40G COMPACT imaging part communicates with the control PC by using Ethernet
[IEEE802.3u (100Base-TX)] to transfer X-ray images.
The control PC performs DICOM transfer in order to use Ethernet to transfer the obtained
images to the printer and storage device.
This section describes how to set up the TCP/IP that is necessary for the network connection.
Set up the following four items:

1) TCP/IP setting for the control PC network card

2) Network setting for Screwcap.ini

3) Network setting stored in the imaging unit
4) Connection setup for a multiple number of sensor units

9.2 Preparation

• Keyboard
• Mouse
Connect the keyboard and mouse to the back of the control PC.
Check if the system is connected, and then turn the system on.
If restrictions have been set on the operation of the operating system, release them.

9.3 Setup Method

9.3.1 TCP/IP Setting for the Control PC Network Card
Perform the set up by referring to "FC-24VE for CXDI Control Station Service Manual" -> the
chapter "System Manual" -> "Network Setup".
Default values
IP Address:192.168.100.10
SubnetMask:255.255.255.0
2. Installation
- 41 -