Replacing An Ekip Com Communication Module - Huawei FusionPower6000 Maintenance Manual

FusionPower6000
Maintenance Guide
Procedure
Step 1 Locate and record the fuse position of the Ekip power module based on the
electrical diagram and label.
Step 2 Push the handle of the Ekip power module fuse outwards and remove the fuse to
disconnect the circuit.
Step 3 Check the Ekip power module terminals using an electroprobe to ensure that the
Ekip power module has no voltage.
Step 4 Mark corresponding port names on the cables of the Ekip power module and
COM communication module, and remove the cables.
Step 5 Remove the Ekip power module and COM communication module.
Figure 6-26 Removing a module
Step 6 Split the Ekip power module and COM communication module.
Step 7 Assemble the new Ekip power module with the removed COM communication
module.
Step 8 Install the Ekip power module and COM communication module, and reinstall the
wiring terminals.
Step 9 Reinstall the fuse to reconnect the circuit.
----End

6.19 Replacing an Ekip COM Communication Module

Prerequisites
●
●
Procedure
Step 1 Locate and record the fuse position of the Ekip power module based on the
electrical diagram and label.
Issue 02 (2022-07-18)
Tools: electroprobe, insulated gloves
Material: a new and intact Ekip COM communication module of the same
model
Copyright © Huawei Digital Power Technologies Co., Ltd.
6 Component Replacement
62