C-100
2-3.
SWITCH COVER (SIDE), MICROPHONE SLEEVE
3 switch cover (side)
Note 3: When installing the switch cover (side),
refer to "HOW TO INSTALL THE
MICROPHONE SLEEVE" on page 7.
2 Pull out the microphone
sleeve block in the direction
of the arrow.
capsule side
6
Note 2: When installing the screw, tighten it
straight so that it does not overlap
OK
NG
center
overlap
screw
microphone sleeve edge
– Top view –
3 switch cover (side)
Note 3: When installing the switch cover (side),
1 screw (M1.7) (L = 4.0 mm)
Note 1: When tightening screw, tighten
screw
4 microphone sleeve
Note 4:
3 switch cover (side)
Note 3: When installing the switch cover (side),
refer to "HOW TO INSTALL THE
MICROPHONE SLEEVE" on page 7.
refer to "HOW TO INSTALL THE
MICROPHONE SLEEVE" on page 7.
the below torque value.
tightening torque:
connector side
logo side
refer to "HOW TO INSTALL THE
MICROPHONE SLEEVE" on page 7.