After Any Installation, Maintenance Or Service - Siemens KION Service Manual

KION / KION-i
Important
Calibration and Functional check

• After any installation, maintenance or service

intervention in KION / KION-i workstation,
perform a "Calibration" and a "Function check"
according to instructions in the KION / KION-i –
Operating Manual.
Service
• The KION / KION-i workstation must
be serviced at regular intervals by
personnel trained and authorized by
Siemens. Any maintenance or service
must be noted in a log book provided.
• It is recommended that maintenance
and service is done as a part of a
service contract with Siemens.
• Preventive maintenance must be performed
every:
– Six months. This corresponds to approx. 1.000
hours of operation calculated as operating time
of 40 hours a week during six months. Details
are found in the Operating Manual.
– Twelve months or every 3000 hours of
operation whichever comes first. Details are
found in this Service Manual, chapter
"Preventive maintenance".
– Three years. The internal battery shall be
replaced every three years according to
instructions in this Service Manual, chapter
"Preventive maintenance".
• Worn-out batteries must be recycled or
disposed of properly according to local
regulations. Recycle facilities may not
be available in all areas.
• Batteries must not be disposed of with
ordinary waste. Discard disposable,
replaced and left-over parts in accor-
dance with appropriate industrial and
environmental standards.
• When handling ESD-sensitive devices,
established procedures must be
observed to prevent damage.
E382 E392E 061 01 02 02
To the responsible service personnel
• The contents of this document are not binding.
If any significant difference is found between the
product and this document, please contact
Siemens for further information.
• We reserve the right to modify products without
amending this document or advising the user.
• Only personnel trained and authorized
by Siemens shall be permitted to
perform service or repair the KION /
KION-i workstation. Only Siemens
genuine spare parts must be used.
PC boards (spare parts) must always be kept in a
package for sensitive electronic devices. Siemens
will not otherwise assume responsibility for the
materials used, the work performed or any
possible consequences of same.
• The device complies to standards and require-
ments as stated in the KION / KION-i workstation
– Operating Manual.
Siemens-Elema AB
Important
1
1 - 3