Table of Contents
Advertisement
Port (Silk
No.
Screen)
8
COM1–COM6
9
Default
10
AC1, AC2
11
12
AI1–AI8
13
AO1–AO6
14
DI1–DI8
2
Typical Cable Connection Scenarios
2.1
Non-Smart Array Controller Scenario
2.1
2.1
1. If the SmartLogger communicates with an inverter over an AC power cable, three fuses, and a
3P3E switch need to be installed to prevent device damage in the case of short circuits.
2. If the SmartLogger communicates with an inverter over an AC power cable, the cable from the
3P3E switch to the fuses and the cable from the busbar to the fuses both need to be prepared
by the customer. Recommended cable: three-core armor cable with the operating voltage to the
ground greater than or equal to 600 V and the cross-sectional area of a single core wire being 4
2
mm
.
3. The power cable delivered with the SmartLogger is 1 meter long, the power adapter cable is 1.5
meters long, the network cable is 2.2 meters long, and the AC power cable is 1.5 meters long.
Reserve the installation positions for components based on the cable lengths.
Function
Description
RS485
Six RS485 ports that can be connected to devices
communications
such as the inverter, cubicle, electricity meter, or EMI.
Resets and restarts the Bluetooth module or resets
the SmartLogger IP address to the default IP address
Default key
(valid within 5 minutes). The default IP address is
192.168.0.10.
Connects to A, B, and C three-phase inputs, and used
AC power cable
for power line communication (PLC/MBUS) with the
ports
inverter. If PLC (MBUS) function is not used, you do
not have to connect cables to these ports.
Shell
N/A
grounding
AI1: 0–10 V input voltage (passive); AI2–AI4: 4–20 mA
Analog input (AI)
and 0–20 mA input current (passive); AI5–AI8: 4–20
mA and 0–20 mA input current (active)
Analog output
4–20 mA, 0–20 mA current output.
(AO)
Digital input (DI)
Connects to a dry contact input.
2
Advertisement
Table of Contents
