Huawei SmartLogger2000-10-B-JP Quick Manual page 17

1. Prepare a cable with an appropriate length, strip a part of the insulation layer, and connect the
stripped cable core to the OVGR.
2. Strip 8 mm of the insulation layer at the other end.
3. Remove the terminal block from the SmartLogger DI port.
4. Connect the stripped cable core to the terminal block of the DI port on the SmartLogger.
5. Insert the terminal block into the SmartLogger DI port.
9
Connecting Network Cables to the Ethernet Electrical Port
1. The SmartLogger provides two Ethernet electrical ports, through which the SmartLogger can
connect to a third-party device.
2. The SmartLogger can connect to a PC through a LAN switch or router over an Ethernet cable. It
can also be directly connected to a PC. Select the connection device based on the actual
networking scenario.
3. Verify that the Ethernet communications cable is no longer than 100 m.
1. Connect one end of the delivered network cable to the Ethernet electrical port of a device.
2. Connect the other end of the network cable to the ETH1 or ETH2 port of the SmartLogger.
Remove the terminal block using a flat-head
screwdriver.
16