Table of Contents
Advertisement
TD220MAX_manual_v11.doc
9.
Set up the Poller as shown below, where 10.4.144.100 is replaced with the IP address of
your base radio. Note: Set GPS Serial Port to None to prevent the utility opening a serial
port.
10. Click Start Polling and observe the message counts and sequence number increment. The
test will show 100% success if all messages sent to the base radio were transmitted over
the air, received by the mobile radio, and forwarded back to the Poller.
05-6906A01
Page 15 of 49
7/31/2014
Advertisement
Table of Contents
