TD220MAX_manual_v11.doc
5.
Configure the Mobile as follows:
-==========================================================================-
A) Timing Source
B) STFP Radio ID
C) STFP Receive Port
D) STFP Transmit Address
E) STFP Transmit Port
F) STFP Epoch Size
G) STFP Slot Delay
H) STFP Send OTA Beacon
I) Timing Signal Timeout
Select a letter to configure an item, <ESC> for the prev menu
-==========================================================================-
A) Transmit Frequency
B) Transmit Frequency
C) Output Power
D) Enable External PA
E) Max Message Age
F) Force Tx Key
TX Key Timeout
Select a letter to configure an item, <ESC> for the prev menu
6.
Reboot the Mobile
7.
Obtain the TD220X Poller (TD220X_Poller.exe) from GE MDS.
8.
In the Poller directory, create or modify the TD220X poller data configuration file
(TD220X_Poller.parms) as shown below.
05-6906A01
System Configuration Menu
OTA
0
53000
x.x.x.x
(Note: Use IP address of Poller PC)
50011
6 sec
2
disabled
60 Seconds
Radio Configuration Menu
219.000000 MHz
219.000000 MHz
2 W
enabled
60 sec
Normal
5 sec
Page 13 of 49
7/31/2014