Philips 32PFS5709/12 Service Manual page 51

4.12.4 Speakers
1. Gently release the tapes that secures the speaker cables.
2. Unplug the speaker connectors from the SSB.
3. Take the speakers out.
When defective, replace the both units.
4.12.5 Stand bracket
1. Remove all fixation screws of the bracket.
2. Lift the bracket from the set.
4.12.6 IR/LED Panel
1. Remove the stand bracket, as described earlier.
2. Remove fixation screw that secure the deco rear cover and
take it out from the deco.
3. Unplug the connector from the IR/LED panel.
4. Gently release the double faced adhesive tape that pasted
the panel and take it out from the deco.
When defective, replace the whole unit.
4.12.7 WIFI module
1. Unplug the connector from the SSB.
2. Remove fixation screw that secure the WIFI module, gently
remove the module from the set.
When defective, replace the whole unit.
4.12.8 LCD Panel
1. Unplug all the connector cables of the boards.
2. Gently take all the speakers out.
3. Lift the subframe with keyboard, SSB, PSU, IR/LED panel,
WIFI module and panel from the LCD panel and put it
aside.
Warning: Cause the panels of 65" 5900 series are bolt-on
panels, the panel could not release from bezel.
When defective, replace the whole unit.
4.13 Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
• While re-assembling, make sure that all cables are placed
and connected in their original position. See
Figure 4-28.
• Pay special attention not to damage the EMC foams on the
SSB shields. Ensure that EMC foams are mounted
correctly.
Mechanical Instructions
Figure 4-1 and
back to
div. table
TPM14.2E LA 4. EN 51
2014-Sep-26