Table of Contents
Advertisement
EN 34
4.
TPM14.2E LA
4.5.4
Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1. Gently unplug all connectors from the PSU.
2. Remove all fixation screws from the PSU.
3. The PSU can be taken out of the set now.
4.5.5
Speakers
1. Gently release the tapes that secures the speaker cables.
2. Unplug the speaker connectors from the SSB.
3. Take the speakers out.
When defective, replace the both units.
4.5.6
Keyboard Control unit
1. Unplug the connector from the keyboard control panel.
2. Gently push inwards the two clips at the PSU side of the
unit. Release the unit at the PSU side and turn it away from
the PSU. Now push it towards the PSU to release the
catches at the other side of the unit. Take it out from the
metal bracket.
When defective, replace the whole unit.
4.5.7
Stand bracket
1. Remove all fixation screws of the bracket.
2. Lift the bracket from the set.
4.5.8
IR/LED Panel
1. Remove the stand bracket, as described earlier.
2. Remove fixation screw that secure the deco rear cover and
take it out from the deco.
3. Unplug the connector from the IR/LED panel.
4. Gently release the double faced adhesive tape that pasted
the panel and take it out from the deco.
When defective, replace the whole unit.
4.5.9
WIFI module
1. Unplug the connector from the SSB.
2. Remove fixation screw that secure the WIFI module, gently
remove the module from the set.
When defective, replace the whole unit.
4.5.10 LCD Panel
1. Unplug all the connector cables of the boards.
2. Gently take all the speakers out.
3. Lift the subframe with SSB, PSU, Keyboard, IR/LED board
and WiFi module, panel from the LCD panel and put it
aside.
Warning: Cause the panels of 55" 6500/6600 series are bolt-on
panels, the panel could not release from bezel.
When defective, replace the whole unit.
4.6
Assembly/Panel Removal ( for 32"/48" 5700
series & 48"/55" 6400 series)
Instructions below apply to the 32PFS5709/12, but will be
similar for other 32"/48" 5700 series & 48"/55" 6400 series
models.
4.6.1
Rear Cover
Refer to
Figure 4-37
for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1. Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
2014-Sep-26
Mechanical Instructions
back to
div. table
screws [2], [3] that secure the rear cover. Refer to
Figure 4-37
for details.
2. Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
Hide quick links:
Advertisement
Table of Contents
