Connect A Ups To A G-2426G-B Ont; Figure 6-7 Ont In Wall Mount Bracket-Facing The Room / Facing The Wall - Nokia ONT Product Manual

Install a G-2426G-B indoor ONT

Connect a UPS to a G-2426G-B ONT

e. Remove the wall mount bracket from the wall.
f. On a flat surface such as a desk, install the ONT into the wall mount bracket by lifting the unit
above the bracket and sliding it downward onto the bottom ledge of the bracket.
g. Seat the ONT into the wall mount bracket by engaging the hooks on the base of the unit with
those on the bracket. Engaging the hooks ensures that the ONT stays in place while the unit
is mounted onto the wall.
h. Mount the unit onto the wall.
i. Connect the cables
Connect the cables. See
Figure 6-7, "ONT in wall mount bracket—facing the room / facing the wall" (p. 77)
mounted unit facing the wall with the cables (including the fiber) installed.
Figure 6-7 ONT in wall mount bracket—facing the room / facing the wall
E
ND OF STEPS
6.9 Connect a UPS to a G-2426G-B ONT
Use this procedure to connect a UPS to indoor or outdoor G-2426G-B ONTs.
See Table 5-3, "G-2426G-B UPS ordering information" (p. 47)
data sheet" for the supported power supplies.
78
Chapter 6, "Install a G-2426G-B indoor
3FE-49441-ABAA-TCZZA
ONT".
36749
in the Chapter 5, "G-2426G-B unit
Nokia ONT
shows the
June 2021
Issue 1