Entré Takes A Long Time To Start Up Or The Standby Light On Entré's Front Panel Flashes When I Turn It On; The Blue Radio And Music Indicators On Entré's Front Panel Are Flashing, Even When Entré Is In Standby; Entré Fails To Respond To Front Panel Or Remote Commands Or Is Responding Erroneously; Entré Locks Up Frequently, Requiring Me To Reset The Processor - Kenwood Sovereign Entre User Manual

Troubleshooting
• Listening to or managing radio stations, see "Managing Your Radio Sta-
tions" on page 123.
• Accessing the Internet, see "Using the Internet" on page 139.
If the problem persists, try restting Entré. See "Entré fails to respond to front
panel or remote commands or is responding erroneously" on page 150.
Entré takes a long time to start up or
The standby light on Entré's front panel flashes when I
turn it on
Entré contains a sophisticated high-capacity music storage system that takes
time to initialize. You should only experience this delay the first time you turn
on Entré or after you have unplugged and re-plugged Entré. The standby light
on the front panel flashes while Entré is warming up. Once it stops flashing,
you are ready to start using Entré.
The blue Radio and Music indicators on Entré's front panel
are flashing, even when Entré is in Standby
1. Entré is compressing WAV audio files into MP3 format "in the back-
ground". You can use Entré normally during this process.
2. Entré attempted to perform an auto software update that was unsuccess-
ful. When you turn Entré on, there will be a message about this on the
screen. After you exit from the message you can use Entré normally.
Entré fails to respond to front panel or remote commands or
is responding erroneously
Reset Entré's microprocessor:
1. Hold
POWER
slowly, then release
2. When the Standby indicator stops flashing and is lit constantly, push
to turn Entré on.
POWER
Entré locks up frequently, requiring me to reset the processor
Turn Entré off when you are not using it. Entré does not need to be on to
receive software updates from the OpenGlobe server.
150
Do not turn Entré on and off rapidly. When you turn Entré
off, leave it off for at least a minute before turning it back on
again, to save wear and tear on the storage system.
down until the Standby indicator begins to flash on and off
.
POWER
Complete Guide to Your Entré Entertainment Hub, ver. 2.0