Mitsubishi Electric C70 Setup Manual page 622

Date of revision Manual No.
Dec. 2006 IB(NA)1500265-A First edition created.
Jan. 2007 IB(NA)1500265-B
Feb.2007 IB(NA)1500265-C
Nov.2007 IB(NA)1500265-E
Jan.2008 IB(NA)1500265-F
Feb.2008 IB(NA)1500265-G
Sep.2009 IB(NA)1500265-J
Jul.2010 IB(NA)1500265-K
Dec. 2010 IB(NA)1500265-L
Jul. 2012 IB(NA)1500265-M
Revision History
Second edition created.
- "I. Procedures for starting up" was entirely revised.
- Multi CPU alarms and parameters were added.
- Explanations of CNC data input/output were moved to the Instruction Manual.
- Mistakes were corrected.
Third edition created.
- The following sections were added to "I. Setup Procedures".
2.5.1 Screen Transition to the CNC Monitor
2.5.3 Setting the Date and Time
3.7 Data Backup
3.8 Data Restoration
- Mistakes were corrected.
Fourth edition created.
- The construction of chapters and sections was revised.
- The following sections were added to "2. Initial Setup".
2.2.1 Initial Setup Flow of GOT
2.2.3.2 Installing Using Compact Flash Card
2.2.4.1 Direct Setting of IP Address Using GOT Utility
2.4.1 Initial Setup Flow of CNC CPU
2.4.2 Connecting Battery to CNC CPU
2.4.3 Initializing CNC CPU Internal Data (Clearing SRAM Data)
- "3. Setting Machine Parameters" was added.
- "4. Cable" was deleted.
- "Appendix 2.1.3 Servo/Spindle alarms" was revised.
- "Appendix 3. Display of 7-segment LED" was added.
- Mistakes were corrected.
Fifth edition created.
- Mistakes were corrected.
Sixth edition created.
- "2.2 GOT Initial Setup" was revised.
- Mistakes were corrected.
Seventh edition created.
Contents were revised to correspond to C70 software version B2.
- Mistakes were corrected.
Eighth edition created.
- Reviewed "Precautions for Safety".
- Corrected the alarms and parameter below.
#1284 ext20 bit0: Spindle speed clamp check
P134 G96 G96 Clamp Err.
M01 1043 No spindle speed clamp
- Corrected the mistakes.
Ninth edition created.
Contents were revised to correspond to C70 software version C5.
- The following section was added to "4.3 Setting Multi-CPU Parameters".
4.2.1 Types of Memory and Backup Data
- The construction of "6. Setting Machine Parameters" was revised and the title was
changed. Also, the following section was added.
6.1.3 Data Protection Key
- Corrected the mistakes.
Tenth edition created.
Contents were revised to correspond to C70 software version D4.
- To correspond to GT Designer3/GX Works2, the following changes were made:
"2.1 GT Designer3" was added
"2.2 GT Designer2" was added
(the former 2.1 to 2.6 were renumbered to 2.2.1 to 2.2.6 respectively)
"3.1 GX Works2" was added
Revision details
(Continued on the following page)