Mitsubishi Electric C70 Setup Manual page 222

【#1227】 aux11
bit0: Select PLC signal or spindle feedrate attained
Set up this option when disabling the cutting start interlock by spindle feedrate attained.
0: Cutting start interlock by PLC signal
1: Cutting start interlock by spindle feedrate attained
bit1: Select H or D code
Set up this option to validate the data that is set up on the tool life management screen when issuing
the H99 or D99 command.
0: The H and D codes validate the data that is set up on the management setup screen.
1: Validates the data that is set up on the management setup screen when issuing the H99 or D99
bit2: Measures against tool setter chattering
Select a condition where a relieving operation completes after measurement with tools.
0: Sensor signals have stopped for 500 ms or longer.
1: 100 μm or longer has passed after sensor signals stopped.
bit4: Program address check
Specify whether to simply check the program addresses when the machining program is executed.
0: Not check the program address.
1: Check the program address.
bit5: Spindle rotation speed clamp
Specify whether to clamp the rotation speed in constant surface speed mode when the spindle
rotation clamp command is issued.
0: Clamps the rotation regardless of the constant surface speed mode.
1: Clamps the rotation only in constant surface speed mode.
bit6: Switch menu type
Set the menu type for the word edit (the parameter "#1139 edtype" is "2").
0: Menu type 1
1: Menu type 2
bit7: Switch the range of tool life data to be input
Set up the range of tool life data to be input or compared.
0: Inputs or compares all of the data output.
1: Inputs or compares part of the data output
1) Tool life management I data to be input or compared tool number (D), lifetime (E), life count (F),
and auxiliary data (B).
2) Tool life management II data to be input or compared Group number (G), method (M), life (E/F),
tool number (D), and compensation number (H)
command.
LOOK UP DELETE REPLACE INSERT
COPY PROGRAM
COM.SRH B.G SRH B.G END COMMENT RETURN
WORD WORD STR. STR.
LOOK UP PROGRAM
COPY DELETE REPLACE INSERT
COM.SRH B.G SRH B.G END COMMENT RETURN
WORD WORD STR. STR.
Appendix 1.3 Base Specifications Parameters
MENU
MENU
RETURN
MENU
MENU
RETURN
C70 Setup Manual
205