Peak Load Prevention; Com Module Selection; Availability Of Miele Digital Products; Wifi / Lan - Miele PDR 914 HP Operating And Installation Instructions

COM module
-

Peak load prevention

With this function, the application of a hygiene programme is not amended when a peak
load signal is in place. The heater stays switched on.
- Factory default: Off
On
-

COM module selection

This tumble dryer is equipped with an integrated WiFi module. However, the dryer can
also be equipped with an external module.
- Factory default:
Off
Internal module
-
The internal WiFi module is used.
- External module
An XKM module is inserted into the module slot.

Availability of Miele digital products

The ability of Miele digital products depends on the availability of the services in your
country.
The different services are not available in all countries.
For information about availability, please visit www.miele.com.

WiFi / LAN

Control the networking of your tumble dryer.
Networking of the tumble dryer for use with the digital Professional tools is only possible
with the external module. The internal module can only be used by the Miele Customer
Service Department.
Deactivate
- (visible when the network is activated)
The network remains set up; the WiFi function is switched off.
Activate
- (visible when the network is deactivated)
The WiFi function is reactivated.
- Connection status
The following values are displayed:
– the quality of WiFi reception
– the network name
– the IP address
- Set up again (visible when set up)
Resets the WiFi login (network) to immediately re-establish a new connection.
Reset
- (visible when set up)
(visible when the network is activated)
Supervisor level
55