End Of The Programme; Removing The Laundry; Care Notes; Timer - Miele PDR 914 HP Operating And Installation Instructions

End of the pro-
gramme
Removing the
laundry

Care notes

Prerequisite for

setting the timer

Setting the timer
vary or "jump". The tumble dryer's electronic module adapts during
the ongoing drying programme. The displayed programme running
time becomes more and more accurate.
When using the programmes for the first time, the displayed time
sometimes deviates significantly from the real time left. The differ-
ence between the estimated and achieved time becomes smaller if
the corresponding programme is run more often. If different load
sizes are dried in one programme, the time left display can only
show an approximate time.

End of the programme

The laundry will be cooled down shortly before the end of the pro-
gramme. The message
during the cooling phase. The laundry can now be removed.
After the cooling phase and the drying programme is completed, the
Finish
message is displayed.
The tumble dryer will switch off automatically after the set time after
the end of a programme.
If the Anti-crease * extra has been selected, the drum continues to
rotate in intervals after the end of the programme. This reduces creas-
ing if the laundry cannot be removed straight away.
* The Anti-crease function is switched off as the factory default set-
ting and can be activated in the Supervisor level.
Open the door.

Remove everything from the drum.

Items left in the tumble dryer could be damaged by overdrying
when the tumble dryer is used the next time.
Always remove all items from the drum.
Switch the tumble dryer off by pressing the  button.

This tumble dryer requires regular maintenance, particularly if it is
used on a continuous basis. Please see "Cleaning and care" for de-
tails.

Timer

The Delay start must be activated in the Supervisor level in the Con-
trols / Display menu so that the Timer can be selected. Before the
programme starts, the Timer can be used to select a programme start
time or programme end time.
Timer
Touch the sensor control.

Finish at
Select the

Set the hours and the minutes and confirm your entry with the

OK sensor control.
Finish/Cool down
Start in Start at
, or option.
will appear on the display
Drying
25