Change The Settings - Canon Color imageCLASS MF8450c Starter Manual

2 Set Up the Machine
Change the Settings
When you change the settings on the machine after finishing the "Setup Guide, " refer to the following
items.
Paper Size/Type:
●
(Main Menu) → <Additional Func.> → <Paper Settings> → Select the drawer → Select the paper size →
Select the paper type →
Machine, " in the e-Manual.)
Date and Time:
●
(Main Menu) → <Additional Func.> → <Timer Settings> → <Date/Time Settings> → <Current Time
Settings> → Enter the date and time →
"Introduction of the Machine, " in the e-Manual.)
Daylight Saving Time:
●
(Main Menu) → <Additional Func.> → <Timer Settings> → <Date/Time Settings> → <Daylight Saving
Time Set.> → Select <On> or <Off> →
"Introduction of the Machine, " in the e-Manual.)
Telephone Number Registration:
●
(Main Menu) → <Additional Func.> → <Communications Settings> → <Fax Settings> → <User
Settings> → <Register Unit Telephone #> → Enter the telephone number, then <Register> →
Menu) to return to the Main Menu screen. (See "Fax, " in the e-Manual.)
Unit Name Registration:
●
(Main Menu) → <Additional Func.> → <Communications Settings> → <Common Settings> → <TX
Settings> → <Register Unit Name> → Enter the unit name, then <Set> →
the Main Menu screen. (See "Fax, " in the e-Manual.)
Receive Mode:
●
(Main Menu) → <Additional Func.> → <Communications Settings> → <Fax Settings> → <RX
Settings> → <Reception Mode Selection> → Select the receive mode →
Main Menu screen. (See "Fax, " in the e-Manual.)
Telephone Line Type:
●
(Main Menu) → <Additional Func.> → <Communications Settings> → <Fax Settings> → <User
Settings> → <Tel. Line Type Selection> → <Manual> → Select the telephone line type →
to return to the Main Menu screen. (See "Fax, " in the e-Manual.)
Auto Gradation Correction:
●
(Main Menu) → <Additional Func.> → <Adjustment/Cleaning> → <Auto Gradation Correction> →
Select the correction type → Perform the correction →
screen. (See "Maintenance, " in the e-Manual.)
Network (Auto):
●
(Main Menu) → <Additional Func.> → <System Management Set.> → <Network Settings> → <Done>
→ <TCP/IP Settings> → <IPv4 Settings> → <IP Address Settings> → <Obtain Automatically> → <DHCP> →
Enter the IP address → Enter the subnet mask → Enter the gateway address number →
to return to the Main Menu screen. → Turn OFF the main power → Restart the machine. (See "Network
Settings, " in the e-Manual.)
36
(Main Menu) to return to the Main Menu screen. (See "Introduction of the
(Main Menu) to return to the Main Menu screen. (See
(Main Menu) to return to the Main Menu screen. (See
(Main Menu) to return to
(Main Menu) to return to the
(Main Menu) to return to the Main Menu
(Main
(Main Menu)
(Main Menu)