Hitachi PC-ARFG-E Installation & Operation Manual page 61

SERVICE & INSTALLATION MENU
Element Optional function
Control in "Automatic" indoor
fan speed mode (supporting
High H)
Models:
RCI-FSR
EF
RCIM-FSRE
RCD-FSR
RPC-FSR
RPI(L/H)-FSRE
RPI-FSN3(P)E(-f)
RPK-FSR(H)M
F0 Not available
Automatic OFF timer setting
Models:
RCI-FSR
RPC-FSR
RPK-FSRM
RPI(L/H)-FSRE
RCD-FSR
RCIM-FSRE
RPI-FSN3(P)E(-f)
F1
Automatic OFF timer setting
Models:
RPF(I)-FSN2E
Remote control primary-
F2
secondary setting
Automatic reset of setting
F3
temperature
(6)
47 PMML0565 rev.1 - 04/2022
Individual
Settings
setting
00 Function disabled
O
01 Function enabled
"- -"
– –
permanent
00 Function disabled (Factory setting)
01 1 hour
02 2 hours
03 3 hours
04-24 (04-24) hours
X 0A 30 minutes
0B 90 minutes
0C 40 minutes
0D 45 minutes
0E 50 minutes
0F 55 minutes
00 Function disabled (Factory setting)
01 1 hour
02 2 hours
X 03 3 hours
04-24 (04-24) hours
0A 30 minutes
0B 90 minutes
Primary (main remote control)
00
(Factory setting)
X
01 Secondary (sub remote control)
00 Function disabled (Factory setting)
X
01 Function enabled
Setting conditions
}
Do not set these
when two wired
controllers are used.
Description
This function limits the speed
of the indoor fan when room
temperature is close to the
setting temperature, allowing to
reach High H speed.
–
This function sets an automatic
OFF timer to switch OFF the
indoor units controlled by the
remote control switch (when
the units have been started by
remote control).
(Do not set the values "0C"-"0F"
when two remote control switches
are used in the same remote
control group).
This function is used to set the
automatic timer to switch off
when the unit has been started
by remote control.
This function is used to define
which remote control switch is
used as primary or secondary,
when two remote controllers are
connected to one indoor unit.
This function is used to limit unit
operation and save energy.
The setting temperature is
automatically set to the value
defined with functions "F5" or
"F6", according to the current
operation mode, after the
time set with function "F4" has
passed since the last manual
change of setting temperature.
In case that the values of "F5"
or "F6" are out of the limits set
with functions "FC" and "Fd",
limitations set by "FC" and "Fd"
have priority.