Hitachi BTN5 Owner's Manual page 5

WARNING: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
- Connect the equipment to an outlet on a circuit different
- Consult the dealer or an experienced radio/TV
Power source
This product is designed to operate on 120 volts 60 Hz, AC current.
Insert the power cord into a 120 volts 60 Hz outlet. To prevent
electric shock, do not use the product's (AC) plug with an extension
cord, receptacle, or other outlet. Never connect the product to 50
Hz, direct current, or anything other than the specified voltage. The
main power cord is the product's disconnect and must remain readily
operable and accessible.
E-WASTE / RECYCLE NOTICE
This product may contain lead and should be disposed or recycled
according to local electronic waste (e-waste) laws. For product recycling
and disposal information, contact your local government agency or www.
eRecycle.org (in California), the Electronic Industries Alliance at www.
ecyclingcentral.com (in the U.S.) or the Electronic Product Stewardship
Canada at www.epsc.ca (in Canada). FOR MORE
INFORMATION, call 800.HITACHI (800.448.2244) (USA/
CANADA).
4
receiver.
from that to which the receiver is connected.
technician for help.