8.12.1 ASSEMBLY INSTRUCTIONS
TOP PREVIOUS NEXT
1. First place the rubber seal over the shaft opening on the bread pan as shown in the figure. (
Fig.19
)
2. Install and align the mounting shaft with the three screw holes on the bread pan. (
3. Reinsert screws and tighten.
Caution :
Do not forget to insert the rubber seal when assembling.
Also be sure not to twist this seal during assembly.
When replacing the shaft mounting unit, be sure to use a new rubber seal (Packing) and three new
screws.
Fig.19
Fig.20
Fig.20
)