Panasonic SD-206 Service Manual page 140
Hide thumbs
Also See for SD-206:
- Operating instructions and recipes (44 pages) ,
- Operating instructions manual (64 pages)
Advertisement
8.2 Remove of PCB (B)
TOP PREVIOUS NEXT
1. Turn the body upside down and remove the four mounting screws in order to remove the feet. (
Fig.6
)
2. Remove the four bottom plate mounting screws in order to remove the Bottom plate.
3. Remove the six screws which secure the heater case from the sides, and then pull upward on
the heater case to remove it. (
4. Pull out and disconnect the connector on the circuit board.
Removal of Positive Lock connector
The positive lock connector is a specialty designed loose connector./To remove this connector,
pull the lead wire by pressing an extruded lever in the center of receptance terminal.
5. Remove the screw.
6. Remove the PCB holder assembly. (
Fig.7
&
Fig.8
)
Fig.9
)
Fig.6
Fig.7
Advertisement
