Panasonic SD-206 Service Manual page 137

8.1 Removal of PCB (A)
TOP PREVIOUS NEXT
1. Remove the two screws on the front rear corner which secures the control panel. (
2. Move front control panel towards the rear and lift off carefully. (
3. Carefully disconnect the PCB cover assembly./Remove the one screw which secures PCB
cover assembly. (
Removal of Positive Lock connector
The positive lock connector is a specialty designed loose free connector./To remove this
connector, pull the lead wire by pressing an extruded lever in the center receptance terminal.
4. Remove the PCB cover assembly by lifting up from the right side.
5. To separate the PCB from the cover assembly, bend back the six holding tabs white lifting out
the PCB. ( Fig.5
Fig.4 )
)
Fig.1
Fig.2
Fig.1
Fig.2 & Fig.3 )
)