Table of Contents
Advertisement
2-4. Replacement of Main Parts
2-4-3. HDD Unit Replacement
When "R" (A rebuild request for HDD has been generated)
is flashing in the upper-right portion of "Home" display, or
when "Non", "Err" or "Req" is generated on the menu
"Disk" display, replace the corresponding HDD unit. (For
the menu operations, refer to the operation manual.)
. "Non" : Not detected
. "Err" : HDD error
. "Req" : HDD exchange request generated
>Exit
Disks
Exchg
Rebuild
-1- -2- -3- -4- -5- -6- -7- -8-
Format Req Rdy Rdy Rdy Rdy Rdy Rdy Rdy
The HDD unit can be replaced during the power on.
n
When replacing the HDD unit during the power on, the
following precautions should be followed.
. Be sure to put on the earth-band to establish a ground. If
not, this may cause malfunction.
. Be careful not to give any shock to another HDD.
. Replace the power supply unit within three minutes in
consideration of air cooling effect.
Replacement part
Please order the RKMA70-D (Recommended Parts Kit) or
RKMA70-R (Recommended Parts Kit).
The RKMA70-R is a recycled hard disk.
2-8 (E)
Remain=100%
Stopping the HDD
Stop the HDD to be replaced using the menu "Disks :
Exchange". (For the menu operations, refer to the opera-
tion manual.)
n
In the menu "Disks : Exchange", the HDD in the "Req"
status is automatically selected.
Set the menu select cursor to "Stop", and press the ENTER
key. The HDD will stop.
Exit
Disks
: Exchange
>Stop
Start
*1* -2- -3- -4- -5- -6- -7- -8-
Req Rdy Rdy Rdy Rdy Rdy Rdy Rdy
Removal procedures
1. Remove the front panel (lower). (Refer to the Section
2-2-1.)
2. Make sure that indicator of the HDD unit to be
replaced lights off.
3. Remove the HDD unit gently while pressing the levers
in the direction of the arrows.
Indicator
HDD unit
Levers
MAV-70
Advertisement
Table of Contents
