Advertisement
Notation of Symbols
• Check/Adjustment indicator:
CHECK
• Half-punch indicator:
Servicing Instruments and Tools That Require Inspection/Calibration
The machine should be installed and serviced by use of servicing instruments and tools that
have been inspected and calibrated as appropriate.
If the machine were serviced using servicing instruments and tools that have not been
inspected and calibrated, proper performance of the machine could not be guaranteed.
Servicing instruments and tools that require inspection/calibration are as listed below.
Inspection/calibration procedures should be performed in accordance with the inspection/
calibration manuals described in the ECN Information.
Instruments and tools that require inspection/calibration
Name
Dosimeter
Steel rule (150mm)
Steel rule (300mm)
Digital tester
Calipers
Push-pull gauge
: A block gauge for use in inspection requires calibration.
009-058-02
009-058-00
08.30.2001 FM3142
10.10.2000 FM2732
Indicates that it is necessary to check or adjust the installa-
tion location when the part or component removed is to be
reinstalled.
This indicator is placed in the illustration that depicts the
procedures for removing the parts and components.
When you see this indicator, refer to its relevant "
Adjustment Procedures."
Indicates that it is necessary to align the half-punches when
installing the parts or components.
However, it is not indicated for the half-punches for improv-
ing ease of assembly or preventing erroneous assembly
procedures.
Inspection
Calibration
–
–
–
( )
–
CR-IR347 Service Manual
Servicing instrument inspection/calibration manual No.
ECO NO. FCR - A014
0.3
Check/
TR7H0002.EPS
0.3
Advertisement
