Programming The Professional Series Radios For Use With A Zr340 Repeater; Overview; Programming; Programming Tools - Motorola CDR500 Programming Manual

Overview

This section describes the programming and setup of
the Professional Series radios for use with a Zetron
ZR340 telephone interconnect repeater controller. Two
Professional Series radios are required; one operates as
the receiver for the repeater and the other operates as
the transmitter of the repeater. For more information
on the ZR340, please refer to the following manual:
6880905Z90 ZR340 Advanced Interconnect
Instruction Manual

Programming

Programming Tools

Professional Series Radios

Use the Professional Series Customer Programming
Software (CPS) to program the receive radio and the
transmit radio (or use archived CPS files for the radios)
for the desired repeater configuration.
ZR340 Advanced Telephone Interconnect
The ZR340 Advanced Telephone Interconnect is pro-
grammed with DTMF sequences from the DTMF pad
on a mobile or portable radio. Refer to the ZR340
instruction manual, 6880905Z90, for programming
information and commands.
Professional Series Radios
Receive Radio Programming
1. Read the Professional Series receive radio.
2. After the radio is read, select "Radio Configu-
ration" from the opening CPS "Tree View"
window.
3. Click the "Basic" tab.
4. If necessary, uncheck the "Hook (HUB)
Defeats PL" selection box. Your screen should
appear similar to Figure 11-1.
5. Click the "Accessory Configuration" tab.
6. Click the "Rx Audio Type:" dropdown arrow
button. Select "Filtered Audio".
March, 2001
Programming the Professional Series Radios
for use with a ZR340 Repeater Controller
6864110R66-O
Figure 11-1. Radio Configuration, Basic,
Receive Radio
7. Click the "Ignition Sense Type:" dropdown
arrow button. Select "On/Off & Ignition".
Your screen should appear similar to see
Figure 11-2.
8. Click the "Accessory Pins" tab.
9. Click the "Accessory Package" dropdown
arrow button. Select "Tel Interconnect (ZR340)
Rx". Verify that pin 4 is "CSQ Detect (Out-
put)", Active Level "High" and pin 12 is "PL
and CSQ Detect/Talkgroup Detect (Output)",
Active Level "Low". Your screen should
appear similar to Figure 11-3.
10. "Close" the "Radio Configuration" window.
11. Click on the + indicator next to "Conventional
Personality" selection from the opening CPS
"Tree View" window.
12. Double click on the "Conventional Personal-
ity - 1" selection.
13. Select the "Basic" tab.
Section 11
11-1