Basic (R*I*C*K) Bi-Directional Repeater - S2 Dip Switch Settings - Motorola CDR500 Programming Manual

CDR500 & CDR700 Repeater Service Manual
13. Click the up-arrow button next to the "Acces-
sory Mic Gain (dB)" display. Each click will
change the gain by 1.5 dB. For use with the
Basic (R*I*C*K), increase the gain to 31.5 dB or
33.0 dB. Your screen should appear similar to
Figure 8-7 on page 8-3.
14. "Close" the Radio Configuration window.
15. Click the + indicator next to "Conventional
Personality" selection from the opening CPS
"Tree View" window.
16. Double click the "Conventional Personality -
1" selection.
17. Select the "Basic" tab.
18. If the radio is a display model (LCD front
panel), you may enter an "Alias" such as
"Repeater TX".
19. Select a "Channel Bandwidth (kHz):" as
defined by the radio licensing authority.
NOTE
In the United States of America, the
Professional Series radios may not be
used legally as the transmit radio in a
UHF (450 to 512 MHz) repeater or base
station application with 12.5 kHz chan-
nel spacing. The ±2.5-ppm frequency sta-
bility capability of the radio does not
meet the requirements of Part 90 of the
Rules and Regulations of the Federal
Communications Commission (FCC). In
other countries, check local frequency
stability requirements before placing a
Professional radio based repeater or base
station in operation.
20. Enter the receive frequency for the transmit
radio of the bi-directional repeater in the "Rx"
area at "Frequency (MHz)".
21. Select the receiver "Squelch Type:" based
upon the type of operation that is required
(CSQ, TPL or DPL).
22. Enter the transmit frequency for the transmit
radio of the bi-directional repeater in the "Tx"
area at "Frequency (MHz)".
23. Select the transmitter "Squelch Type:" based
upon the type of operation that is required
(CSQ, TPL or DPL). Your screen should
appear similar to Figure 8-13.
24. Enter any special programming requirements
in the appropriate windows.
March, 2001
Programming Professional Series Radios for use with a Basic Repeater Controller
Figure 8-13. Conventional Personality, Basic,
25. Assign the personality to a zone in the "Per-
sonality Assignment to Zone" selection win-
dows.
26. Program the transmit radio.
Basic (R*I*C*K) Bi-directional Repeater –
S2 DIP Switch Settings
Set the 12 positions of DIP switch S2 according to the
following information:
1. The repeater is bi-directional: S2-1 "ON".
2. The pin 14 COR signal of the receive radio
will key the transmit radio: S2-2 "ON" and S2-
3 "OFF".
3. There isn't any remote control to be used with
the repeater: S2-4 "OFF".
4. We will use normal receiver and transmitter
audios from the radios; S2-5 "OFF", S2-6
"ON", S2-8 "ON" and S2-9 "OFF".
5. The audio gate in the Basic controller will be
used: S2-7 "OFF".
6. The bi-directional repeater will use the short-
est dropout delay: S2-10 and S2-11 "ON".
7. The configuration is standard: S2-12 "OFF".
The DIP switch should look similar to Figure 8-14.
6864110R66-O
Bi-directional Repeater
Transmit Radio
8-7