Installing An Alternate Emulation - Fujitsu 10 ppm User Manual

Installing an
Alternate
Emulation
User's Manual
Notice:
Do not touch any connector contacts to avoid possible electrostatic
damage to the printer.
Important:
When installing two RAM cards, first install the lower one, and then the
upper one.
Turn power on. If necessary, change buffer memory assignment (page
protect or jam recovery) using the control panel.
Alternate emulations are offered with emulation cards. You can use these
emulations to connect your printer to different computers. The FPS card
(PostScript Level 2 compatible) is available.
The installation procedure is the same as that for the RAM card.
To install an alternate emulation, follow these steps:
1. If RAM cards are already installed, remove them.
2. Insert the emulation card into the bottom black connector.
3. Reinstall the RAM cards.

Installing an Alternate Emulation

3. Install the RAM card. Push
its top edge downwards so
that holes of the card align
with locating pins of the
connector and the card is
secured by retaining clips.
To remove an unsealed RAM
card push out the retaining
clips. When, the card slants
outwards pull the card to
remove.
ENHANCING &
CUSTOMIZING
4-3