Operational Problems - Fujitsu 10 ppm User Manual

Operational Problems

Operational
Problems
6-8
The table below contains advice on dealing with repeated paper feed
problems.
Problem
Paper does not feed cleanly
from paper tray
Problem
No power when you turn on
the printer
Printer does not initialize
Printer initializes, but does not
online
Printer initializes, but the
settings are wrong
Causes and solutions
Top edge of paper stack may be
deformed (wavy or bent sheets). Try
turning the paper stack around.
Paper stack may not be aligned
properly. Pull out the tray, straighten
the paper stack against the paper
guides, and re-insert the tray.
Too many sheets in the paper stack.
Make sure the stack is level with or
below the limit mark on the left paper
guide.
The paper pressure plate may not be
released. Pull out the tray and insert
the tray again until it clicks up.
Solutions
Check that the power cord is
plugged in at both ends and that the
power outlet has power.
Close the upper door completely.
Push down (lock) the paper guide
(inside the rear stacker) in position.
Install a print unit.
Insert the paper tray all the way.
Use the control panel to select the
desired settings.
User's Manual