2600-00CTEIGAA
Ver.
ANNEX C. Assembling connector
C.7 Finishing connector connection with the tape
Finishing the connection between connectors with the tape (Insulation tape, rubber tape) at
outdoor environment is as follows:
1) Overlap (of the half-width of rubber tape) the exposed areas of the connection between connectors with
rubber tap, press lightly to give a good adhesion.
2) Wrap the insulation tape more than two times on top of rubber tape overlapping. When you cut the tape,
cleanly cut using scissors or knives
3) Tie the end of insulating tape using the cable tie to prevent slips at the end of the insulating tape.
Rubber tape
Insulation tape
C-14
4.0
Figure C.14 Finishing connector connection with the tape
Cable Tie
© SAMSUNG Electronics Co., Ltd.