Philips Avent Plus SCF373/11 User Manual page 17

Pumping instructions
Warning: Before you remove the pump body from your breast, always switch off the
breast pump to release the vacuum.
Warning: Do not continue pumping for more than 5 minutes at a time if you do not
succeed in expressing any milk. Try to express at another time during the day.
Warning: If the process becomes very uncomfortable or painful, stop using the pump
and consult your healthcare professional.
Note: If you regularly express more than 125 ml/4 fl oz per session, you can purchase and use a
260 ml/9 fl oz Philips Avent Natural bottle to prevent overfilling and spillage.
1. Wash your hands
thoroughly with soap
and water and make
sure that your breast is
clean.
5. Use the 'level up' and
'level down' buttons to
change the suction
level to your
preference.
2. Place the breast
pump kit onto your
breast. Make sure that
you center your nipple.
90 sec.
6. After 90 seconds the
breast pump will switch
smoothly to expression
mode and slowly
increase its vacuum to
the last used
expression suction level
(or level 11 when used
for the first time).
3 sec.
3. Press and hold the
on/off button until the
device switches on. The
indicator lights go on to
indicate that the device
is in stimulation mode.
7. If your milk starts
flowing earlier or if you
want to switch from
expression to
stimulation mode, you
can switch modes with
the mode selection
button.
English
4. The breast pump
starts in stimulation
mode and slowly
increases its vacuum to
the last used
stimulation suction
level (or level 5 when
used for the first time).
8. Briefly press the
on/off button if you
want to pause. To
continue, briefly press
the on/off button
again.
17