Configuration; Browser Connection; Establishing The Network; Protected Network - Bosch FLEXIDOME panoramic 5100i IR Installation Manual

FLEXIDOME panoramic 5100i IR
6

Configuration

6.1

Browser connection

A computer with a web browser (Google Chrome, Microsoft Edge, or Mozilla Firefox) is used
to receive live images, control the unit, and replay stored sequences. The unit is configured
over the network using the browser.
6.1.1

Establishing the network

The unit must have a valid IP address to operate on your network and a compatible subnet
mask.
By default, DHCP is pre-set at the factory to On plus Link-Local so a DHCP server assigns an
IP address or, if no DHCP server is available, a link-local address (auto-IP) is assigned within
the range 169.254.1.0 to 169.254.254.255.
You can use the Configuration Manager to find the IP address. Download the software from
http://downloadstore.boschsecurity.com.
1.
2.
3.
6.1.2

Protected network

If a RADIUS server is used for network access control (802.1x authentication), the unit must
be configured first. To configure the unit, connect it directly to a computer using a network
cable and configure the two parameters, Identity and Password. Only after these have been
configured can communication with the unit via the network occur.
Bosch Security Systems B.V.
Start the Web browser.
Enter the IP address of the unit as the URL.
During initial installation, confirm any security questions that appear.
Installation manual
Configuration | en
2022-01 | V01 | F.01U.385.630
25