BTS3900 GSM
Commissioning Guide
4
Starting the Site Maintenance Terminal
About This Chapter
Before starting the Site Maintenance Terminal, firstly, set the IP address of the Site Maintenance
Terminal PC; secondly, connect the Site Maintenance Terminal PC to the BTS; finally, log in
to the Site Maintenance Terminal.
4.1 Setting the IP Address of the Site Maintenance Terminal PC
This describes how to set the IP address of the Site Maintenance Terminal PC to the same network
segment as the IP address (192.168.0.72/255.255.255.0) of the BTS.
4.2 Connecting the Site Maintenance Terminal PC to the BTS
To operate and maintain the BTS on the Site Maintenance Terminal, the Site Maintenance
Terminal PC should be connected to the ETH port on the main control module of the BTS using
the crossover cable.
4.3 Locally Logging In to the BTS
You can run the Site Maintenance Terminal to directly log in to the BTS.
Issue 03 (2008-07-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
4 Starting the Site Maintenance Terminal System
System
4-1