September 2004
Wiring an RS232 Interface
(cont.)
1-10
3. Feed the flying leads end of the cable through the conduit hole and
wire the leads to the COMMUNICATON terminal block as shown
in Figure 1-4 on page 1-14. Connect the other end of the cable to
the printer, ANSI terminal or personal computer, and secure the
cable clamp.
!ATTENTION EUROPEAN CUSTOMERS!
To meet CE Mark requirements, all cables must be installed
as described in Appendix B, CE Mark Compliance.
After the wiring has been completed, reinstall the plastic shroud,
replace the front cover on the enclosure and tighten the screws.
Consult the User's Manual for the external device to configure it for
use with the AT868.
Installation