Operations - Sony BKS-R1608 Operation Manual

Operations

Select the destination first, then the source following
the procedure below.
Before starting opertion, turn the power to the unit and
the system on. Then check that the lamp on the PROT
button is not lit.
Selecting a destination and source
1
Press one of the destination select buttons to select
a destination.
The pressed button lights in bright amber.
If no destination select function has been set on
this unit, this step is not necessary. The destination
set at the control terminal is automatically selected.
2
Press one of the source select buttons to select a
source.
The pressed button lights in bright green, and the
crosspoint including the selected source is
switched.
Conditions of the source-select buttons when
a destination is selected:
When there is a source button selected for the
destination on the panel, a source button selected for
the destination is lit in bright green.
When there is not the source button selected for the
destination on the panel, all the source buttons are lit
in dim green.
14 (E)
Selecting when the unit is connected to
the monitor S-BUS data link
When an optional BKDS-V3292B Monitor Board is
installed in the DVS-V3232B/V6464B Video Routing
Switcher and you wish to monitor the input and output
signals, you may switch the monitor signals using the
BKS-R1608/R3209. Before switching signals with
this unit, you should make the signal settings at the
control terminal.
For details on making the settings, refer to the Installation
Manual supplied with the routing switcher.
To monitor the input and output signals, press a select
button to select a monitor signal, and the button lights
in bright green.
Note
To switch monitor signals using the BKS-R1608/
R3209, system software that is version 3.10 or above
should be installed.
Error indication
When trouble occurs with this unit, the ERROR
indicator lights. Pressing one of the buttons on the
front panel makes the indicator go out.