Table of Contents
Advertisement
Preparations
Settings on the Control Terminal
Before switching signals with this unit, the following
preparations should be made on the control terminal
connected to the primary station of the S-BUS data
link.
For details on making the settings, refer to the Installation
Manual supplied with the routing switcher.
1
Set the type of the input and output connector
name to either the type name and number mode or
the description name mode.
2
Set the type names of sources, such as VTR, FLM,
AUX, etc.
Up to 16 type names may be set.
3
Set the source names using a type name and
number from 001 to 999, such as FLM034.
A list of the registered source names is called the
source table.
4
Set the destination names using a type name and
number from 001 to 999, such as VTR089.
A list of the registered destination names is called
the destination table.
5
Set the phantom names.
A list of the registered phantom names is called the
phantom table.
6
Assign the source and destination select buttons.
7
Set the level to be controlled.
8
Set the mother unit and daughter units when
multiple control units are to be used in
combination as follows:
For the mother unit
PANEL mode: MOTHER
SET BLOCK NUMBER: Block number used (1
through 10)
For daughter units
PANEL mode: DAUGHTER
MOTHER STATION ID: Station ID of the mother
unit
Note
Set the mother unit first.
9
Make the route setting if the route function is to be
used.
Preparation for the BKS-R1608/
R3209
You may use up to 253 units of the control unit,
including this unit, in combination to expand the
number of sources and destinations, or use the unit
alone. The required settings may differ depending on
whether it is used alone or in combination. Make the
necessary settings shown below to fit your system.
When multiple units are used in combination, define
one as the mother unit, and the others as daughter
units.
Setting the station number
Set the station number using the STATION ID switch
on the rear panel. The station number is obtained by
adding the binary place values of the switches that are
set to ON.
STATION ID
1 2 3 4 5 6 7 8
1
4
16
64
2
8
32
128
Set Station number: 1+2+8=11
Examples of setting a station number
ON
OFF
← These are the binary place
values of the switches.
11 (E)
Advertisement
Chapters
Table of Contents
