Sony Bravia Theatre Sync RHT-G800 Control Manual page 4

Preparing for the HDMI
CONTROL functions
Before you use the HDMI CONTROL function,
be sure you have performed the following
procedures.
For details on setting the TV and connected
component, see the operating instructions of
them.
Input
buttons
(DVD/BD,
SAT)
4
GB
1
Make sure that the stand is connected
to the TV and connected component
(which should be compatible with the
HDMI CONTROL functions) using a
HDMI cable (not supplied).
2
Turn on the TV, and set the HDMI
CONTROL to "ON," then switch to the
HDMI input connected to the stand.
3
Press ?/1 to turn on the stand, and
then set HDMI CONTROL to "ON" as
follows.
1 Press AMP MENU.
?/1
2 Press x to select "CUSTOMIZE,"
3 Press
4 Press
4
Turn on the connected component.
C, X, x, c,
5
Select the input connected to the
component you want to watch (DVD/
BD, SAT, etc,.) of the stand and TV, so
that an image from the connected
component is displayed.
Set the HDMI CONTROL of the
connected component to "ON."
6
Repeat steps 4 and 5 for each
connected component you want to use
the HDMI CONTROL function.
Reconnecting components
Perform step 5 on this page, then output
AMP
video signals to the TV.
MENU
"LEVEL" appears on the display.
then press or c.
"HDMI CTRL" appears on the display.
or c, and then press X.
"CTRL ON" flashes on the display.
.
"CTRL ON" appears on the display for
a few seconds, and then the menu return
to the normal display. HDMI
CONTROL function is set to ON.